Jump Starter Amps Explained: 1000A vs. 1500A vs. 2000A vs. 3000A
Short answer: Choose a jump starter by your engine's size and fuel type, not by the amp number alone. In the NOCO Boost lineup Pro-Guide carries:
- 500A (GB20) handles gas engines up to 4 liters.
- 1,000A (GB40) handles gas up to 6L and diesel up to 3L.
- 1,500A (GB50) handles gas up to 7L and diesel up to 4.5L.
- 2,000A (GB70) handles gas up to 8L and diesel up to 6L.
- 3,000A (GB150) handles gas up to 9L and diesel up to 7L.
Diesels and cold weather need more, so size up when in doubt.
A portable lithium jump starter starts a dead 12V battery without a second vehicle. This guide explains what the amp rating means, how to match it to your engine, and which features matter on a boat, truck or RV.
Key Takeaways
- Size by engine, not amps: each model is rated for a maximum gas and diesel engine displacement.
- Diesels need more: the same pack covers a much smaller diesel than gas engine.
- Bigger packs do more per charge: up to 20 jump starts for the 500A and 1,000A, and up to 80 for the 3,000A.
- Safety is built in: all five are spark-proof with reverse polarity protection.
- They double as power banks: they recharge phones over USB, and the 2,000A and 3,000A also power 12V devices.
What the Amp Rating Means
The amp number on a jump starter (500A, 1,000A, 3,000A) is the pack's rated output for starting. It isn't the same measurement as a battery's cold cranking amps (CCA), so don't compare the two directly. The practical guide is the engine-size rating each manufacturer publishes. It already accounts for the current a gas or diesel engine of that size needs to turn over.
Diesel engines run at much higher compression, so they need far more current to crank than a gas engine of the same size. That's why the 1,000A GB40 covers a 6-liter gas engine but only a 3-liter diesel.
Jump Starter Size Chart
| Model | Rating | Gas engines up to | Diesel engines up to | Jump starts per charge | Flashlight |
| NOCO GB20 | 500A | 4.0L | — | Up to 20 | 100 lumens |
| NOCO GB40 | 1,000A | 6.0L | 3.0L | Up to 20 | 100 lumens |
| NOCO GB50 | 1,500A | 7.0L | 4.5L | Up to 30 | 200 lumens |
| NOCO GB70 | 2,000A | 8.0L | 6.0L | Up to 40 | 400 lumens |
| NOCO GB150 | 3,000A | 9.0L | 7.0L | Up to 80 | 500 lumens |
All five have spark-proof connections and reverse polarity protection, recharge phones and tablets over USB, and include a flashlight with seven modes including SOS. The GB70 and GB150 also power 12V devices such as tire inflators and power inverters. The GB50 holds its charge for up to a year and adds hot and cold indicators for its internal battery.

How to Choose
- Find your engine displacement in liters, from the owner's manual or engine label, and note whether it's gas or diesel.
- Pick the smallest model rated above it. For a 5.7L gas V8, that's the GB40 (6L). For a 6.7L diesel, it's the GB150 (7L diesel).
- Size up for cold climates, deeply drained batteries or several vehicles. Extra capacity also means more jump starts between recharges.
- Think about where you'll use it. On a boat, a self-contained pack beats jumper cables because there's rarely a second battery alongside.
1,000A vs. 3,000A: Which Do You Need?
- 1,000A (GB40): right for most cars, small SUVs, boats with mid-size outboards, and lawn equipment. Gas engines up to 6L and diesel up to 3L, in the most compact and affordable pack.
- 3,000A (GB150): for big trucks, large diesels, RVs and work fleets. Gas up to 9L and diesel up to 7L, with up to 80 jump starts per charge, a 500-lumen light and 12V output.
- In between: the 1,500A GB50 covers most V8 gas engines and small diesels. The 2,000A GB70 covers most full-size diesel pickups up to 6L.
Example Matches by Engine Size
Use your engine's displacement and fuel type, then pick the smallest model rated above it:
| Engine | Smallest model that covers it | Size up to |
| Small gas engine up to 4.0L (compact car, ATV, motorcycle, mower) | 500A GB20 | 1,000A GB40 for cold climates |
| Gas engine 4.0 to 6.0L (most V6s and many V8s) | 1,000A GB40 | 1,500A GB50 |
| Gas engine 6.0 to 7.0L | 1,500A GB50 | 2,000A GB70 |
| Gas engine 7.0 to 8.0L | 2,000A GB70 | 3,000A GB150 |
| Gas engine 8.0 to 9.0L | 3,000A GB150 | — |
| Diesel up to 3.0L | 1,000A GB40 | 1,500A GB50 |
| Diesel 3.0 to 4.5L | 1,500A GB50 | 2,000A GB70 |
| Diesel 4.5 to 6.0L | 2,000A GB70 | 3,000A GB150 |
| Diesel 6.0 to 7.0L | 3,000A GB150 | — |
If you own several vehicles, size for the largest engine. A higher-rated pack works on every smaller engine too. Boats, trucks and RVs that sit for weeks between uses are good candidates for sizing up, because their batteries tend to be more deeply drained when they fail to start.
Features Compared
| Model | Phone recharges | 12V output | Flashlight | Extras |
| 500A GB20 | Up to 4 | — | 100 lumens, 7 modes | Precision Boost clamps |
| 1,000A GB40 | Up to 4 | — | 100 lumens, 7 modes | Covers small diesels up to 3L |
| 1,500A GB50 | Up to 6 | — | 200 lumens, 7 modes | Holds charge up to 1 year; hot and cold indicators; HD Precision Boost clamps |
| 2,000A GB70 | Up to 6 | Yes | 400 lumens, 7 modes | Powers tire inflators and inverters |
| 3,000A GB150 | Up to 6 | Yes | 500 lumens, 7 modes | Up to 80 jump starts per charge |

Jump Starters on Boats
A dead starting battery on the water is a bigger problem than in a parking lot. There's rarely a second vehicle to jump from, and a long paddle or tow is the alternative. A charged jump starter in a dry hatch is cheap insurance:
- Size it for the outboard or inboard: check the engine's displacement in liters in its manual and use the chart above.
- Keep it dry and charged: store it in a sealed bag or dry compartment and top it up before each season.
- Better still, prevent the dead battery: a separate starting battery that isn't drained by electronics or the trolling motor is the best protection. Read Should You Run a Separate Battery for Your Boat Electronics? and the best marine starting battery guide.
How to Use a Jump Starter Safely
- Turn off the ignition and accessories.
- Connect the red clamp to the battery's positive (+) terminal and the black clamp to the negative (−) terminal or a solid ground.
- Turn the jump starter on and wait for its ready indicator.
- Crank the engine. If it doesn't start, wait before trying again, as the manual directs.
- Once running, turn the pack off and remove the clamps, black first.
- Recharge the jump starter so it's ready next time.
Always follow the jump starter's manual. For lithium vehicle or boat batteries, check the battery maker's guidance first. Many have their own recovery feature, such as Pro-Boost on Pro-Guide lithium batteries. Prefer cables? See the jumper cable gauge guide.
Caring for Your Jump Starter
- Recharge after every use so it's full for the next emergency.
- Top it up every few months in storage, even if you haven't used it. The GB50 is rated to hold its charge for up to a year.
- Mind the temperature: don't leave the pack in a hot dashboard or a freezing trunk for long periods. The GB50's hot and cold indicators warn when its internal battery is outside operating temperature.
- Keep the clamps clean and stored so they can't touch each other.
When a Jump Start Isn't Enough
A jump starter gets you running, but it doesn't fix the reason the battery died. If you need jumps often, or the battery dies again after a short run, it's time to test or replace the battery. Common causes include an aging lead-acid battery, accessories left on, a parasitic drain, or a charging system that isn't keeping up. For cranking replacements, compare our AGM batteries and lithium starting batteries.
Frequently Asked Questions
How many amps do I need in a jump starter?
Match it to your engine. In the NOCO Boost line, 500A covers gas engines up to 4L, 1,000A up to 6L gas or 3L diesel, 1,500A up to 7L gas or 4.5L diesel, 2,000A up to 8L gas or 6L diesel, and 3,000A up to 9L gas or 7L diesel.
Is a 1000 amp jump starter enough?
For most cars, small SUVs and boats, yes. The 1,000A GB40 is rated for gas engines up to 6 liters and diesel engines up to 3 liters.
What is a 3000 amp jump starter good for?
Large trucks, big diesels and RVs. The 3,000A GB150 is rated for gas engines up to 9 liters and diesel engines up to 7 liters, with up to 80 jump starts per charge.
Can I use a jump starter on a boat?
Yes. A portable jump starter is ideal on a boat because you don't need a second battery or vehicle. Choose a model rated for your engine's displacement.
Is a higher-amp jump starter safe on a small engine?
Yes. The engine draws only the current it needs, so a larger pack works on a smaller engine. It just costs more and weighs more than you need.
What's the difference between a jump starter and jumper cables?
Jumper cables need a second vehicle with a good battery. A jump starter is a self-contained lithium battery pack, so you can start your vehicle alone.
How long does a jump starter hold its charge?
It depends on the model and storage conditions. The NOCO GB50 is rated to hold its charge for up to a year. Recharge any jump starter after each use and top it up every few months so it's ready when you need it.
Can a jump starter charge a dead battery?
No. A jump starter delivers a short burst of power to start the engine. Once the engine is running, the vehicle's charging system takes over. To fully recharge a deeply drained battery, use a proper battery charger.
Will a 1000 amp jump starter start a diesel?
A small one. The 1,000A NOCO GB40 is rated for diesel engines up to 3 liters. Larger diesels need the 1,500A GB50 (up to 4.5L), the 2,000A GB70 (up to 6L) or the 3,000A GB150 (up to 7L).
Shop Jump Starters
Find your engine size, pick the model rated above it, and keep it charged in your truck, boat or RV.
Need more power? See the 1,500A, 2,000A and 3,000A models, or call our team at 1-800-827-3232.
Built for the Water. Powered by Pro-Guide.
